Removing A Vrm - Dell Precision Workstation 450 User Manual

3 connector
3. Align the notch on the bottom of the VRM with the ridges inside the connector.
4. Press the VRM straight down into the connector until the securing clips snap into place at the ends of the module.
5. Install the microprocessor airflow shroud (for the Dell Precision 650 computer, see
computer, see "Microprocessor Airflow
6. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7. Connect your computer and devices to electrical outlets, and turn them on.

Removing a VRM

CAUTION: Before you perform this procedure, follow the safety instructions in the System Information Guide.
1. Remove the microprocessor airflow shroud (for the Dell Precision 650 computer, see
computer, see "Microprocessor Airflow
2. Press the securing clips at each end of the connector outward simultaneously until the VRM slightly pops out from the connector.
3. Grasp the VRM by its top corners, and ease it out of the connector.
4. If you are installing a new VRM, see
If you are not installing a new VRM, continue with step 5.
5. Install the microprocessor airflow shroud (for the Dell Precision 650 computer, see
computer, see "Microprocessor Airflow
6. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
Shroud").
Shroud").
"Installing a VRM."
Shroud").
"Microprocessor Airflow Shroud" or for the Dell Precision 450
"Microprocessor Airflow Shroud" or for the Dell Precision 450
"Microprocessor Airflow Shroud" or for the Dell Precision 450