Dell Precision WorkStation 610 User Manual page 105

WARNING: Could not
configure Plug and Play
Card Name.
WARNING: Could not
configure PCI device,
ID=DeviceID.
Failed to configure Number
of Total Count Plug and
Play ISA devices. Use your
system's configuration
utility to resolve conflicts.
Press any key to continue.
WARNING: Could not
configure Plug and Play
Card Name.
WARNING: Could not
configure PCI device,
ID=DeviceID.
Failed to configure Number
of Total Count Plug and
Play ISA devices. Use your
system's configuration
utility to resolve conflicts.
Press any key to continue.
WARNING: Boot Device
conflict detected! CSN=Card
Select Number Error=Error.
The card(s) mentioned
are not fully configured
due to resource
conflicts.
The card(s) mentioned
are not fully configured
due to resource
conflicts.
One of the devices is
attempting to use one
or more resources
If you still receive the error message, contact the manufacturer of the
Plug and Play expansion card for assistance.
If you have documentation that lists the allowable resource values for
your Plug and Play or PCI expansion card, you can use the following
procedure to locate and resolve the resource conflict.
NOTE: If you do not have documentation listing the allowable
resource values, see the corrective action for these messages on the
following page.
1. Start the ICU.
Any Plug and Play or PCI expansion cards that could not be
configured should be marked config err in the list of cards in
the ICU window.
2. Select the System Resources option from the View menu.
The System Resource Usage dialog box displays all resources
currently used by the system.
3. Select one of the resources used by your Plug and Play or
PCI expansion card, and click the Used By Card button.
The Card Resources Usage dialog box identifies which device
is using the resource.
4. Repeat step 3 until you have identified all conflicting resources
and the cards that use them.
5. Modify the cards as needed to free the resources required by
the unconfigured Plug and Play or PCI expansion card.
Card" for instructions.
See "Modifying a
If you do not know the allowable resource values for your Plug and
Play or PCI expansion card, use the following procedure to locate and
resolve the resource conflict:
1. Remove all card configurations from the ICU.
See "Removing a
2.
Reboot your system.
The ICU should automatically configure your Plug and Play or
PCI expansion card.
3. Add the ISA expansion cards back into the ICU, resolving any
resource conflicts as they arise.
See "Adding a Listed
If your Plug and Play or PCI expansion card is not automatically
configured when you reboot the system with all other cards removed,
you should contact the manufacturer of the card or see the chapter
titled "Getting Help" in your Diagnostics and Troubleshooting Guide.
Perform the following procedure:
1. Start the ICU.
Card" for instructions.
Card" for instructions.