JBL ON AIR CONTROL 2.4G AW Owner's Manual page 5

CONNECTIONS
Notes: For the sake of simplicity, throughout this manual we have
used the term "source" when describing connections and operation.
This would apply to any device such as an A/V receiver, audio
component, computer or portable music player.
The JBL On Air may be connected to your source in several ways.
First, determine how you would like to use the JBL On Air
Control 2.4G AW; then follow the setup instructions for that
application.
Application 1
Adding surround speakers to a home theater system.
Continue reading the instructions for Application 1 below.
Application 2
Adding speakers to remote locations around your home.
Application 1
Adding surround speakers to a home theater system:
Determine if your source contains preamp outputs for rear/surround
channels, usually indicated by RCA-type jacks on the back of the
receiver labeled as "surround preout" (please refer to your source's
owner's manual to confirm whether it includes the preamp outputs).
If your receiver includes these outputs, follow the steps below.
If not, connection is not recommended.
NOTE: Make sure power is turned off on all components.
Step 1.
Connect the interconnect cable (included) to the left and right
surround/rear preamp outputs on the back of your source and the
input on the transmitter module
Figure 1.
, as shown in Figure 1.
RECEIVER/PROCESSOR
Surround Channel
Preamp Outputs
R
L
ID
CODE
R L
1 2 3 4 INPUT
Step 2.
Determine the location of the surround speakers.
Left Front Center
Channel Channel
Couch
Left
Surround
Channel
Subwoofer
Right Front
Channel
Center
Channel
Left Front
Channel
Left
Surround
Channel
Figure 2. Place the active (left) speaker in the recommended
location for the left surround speaker.
Subwoofer
Right Front
Channel
Right
Surround
Channel
Right
Surround
Channel
5