Table of Contents
Advertisement
Display
No access.
Could not connect.
Wi-Fi connection
terminated.
Lens error
Communications error
System error
E92
Cause/Solution
The camera could not receive the communication signal
from the smart device. Set Wi-Fi network to On in Wi-
Fi options in the setup menu, and wirelessly connect
the camera and smart device again.
The camera failed to establish the connection while
receiving the communication signals from the smart
device. Select a different channel in Channel in Wi-Fi
options in the setup menu and establish the wireless
connection again.
A cable was connected to the camera while the camera
and smart device were wirelessly connected, the battery
level became low, or the connection was aborted due to
poor connectivity. Disconnect the cable and establish
the wireless connection again.
A lens error occurred.
Turn the camera off and then on again. If the error
persists, contact your retailer or Nikon-authorized service
representative.
An error occurred while communicating with the printer.
Turn the camera off and reconnect the USB cable.
An error occurred in the camera's internal circuitry.
Turn the camera off, remove and reinsert the battery, and
turn the camera on. If the error persists, contact your
retailer or Nikon-authorized service representative.
A
81,
E85
81,
E85
81,
E85
20
E25
10, 20
Advertisement
Table of Contents
