Sony DVP-NS705V Service Manual page 5

2. DISC REMOVAL PROCEDURE
(at POWER OFF)
1) Insert a tapering driver into the aperture of the unit bottom,
and move the lever of chuck cam in the direction of the arrow
A. (See Fig. 1)
2) Draw out the tray in the direction of the arrow B, and remove
a disc. (See Fig. 1)
Aperture
B
Tray
A
3. HOW TO SERVICE MB-105 BOARD
• Use the service jig.
CK-122 board
Stand
(J-6090-129-A)
CK-121 board
(J-6090-132-A)
CK-120 board
(J-6090-127-A)
Five flexible flat cables
FFC 26P J-6090-117-A
FFC-9P J-6090-118-A
FFC-5P J-6090-119-A
FFC-15P J-6090-121-A
FFC 25P J-6090-122-A
Lever of chuck cam
Fig. 1
Harness 6P
(J-6090-126-A)
1) Remove the case from the set. (Refer to 2-1)
2) Remove the MB-105 board from the set. (Refer to 2-4)
3) Set the MB-105 board as shown in Fig. 2.
1 MB-105 board
4 Two screws
(B3)
3 Connector
(CN101)
2 Stand
4) Set the CK-120 board as shown in Fig. 3.
5 Connector
(CN101)
6 Flexible flat cables
(FMM-035: CN201)
4 Connector
(CN102)
– 5 –
6 CK-122 board
5 Connector
(CN601)
Fig. 2
6 Two flexible flat cables
(FMO-001: CN203,
FMO-002: CN204)
2 Four screws
(B3)
1 CK-120
board
3 Connector (CN601)
Fig. 3