Battery Charger - Sony Cyber-shot DSC-TX7 Instruction Manual

Battery charger

• Only NP-BN-type battery packs (and no others) can be charged in the battery charger (supplied).
Batteries other than the specified kind may leak, overheat, or explode if you attempt to charge them,
posing a risk of injury from electrocution and burns.
• The CHARGE lamp on the supplied battery charger has the following two flash patterns.
Fast flash: The lamp repeatedly flashes on and off at approximately 0.15-second intervals.
Slow flash: The lamp repeatedly flashes on and off at approximately 1.5-second intervals.
• Remove the charged battery pack from the battery charger. If you leave the charged battery pack in the
charger, battery life may be shortened.
• When the CHARGE lamp flashes, remove the battery pack being charged, and then insert the same
battery pack into the battery charger again until it clicks. When the CHARGE lamp flashes again, this
may indicate a battery error or that a battery pack other than the specified type has been inserted. Check
that the battery pack is the specified type. If the battery pack is the specified type, remove the battery
pack, replace it with new one or another one and check if the battery charger operates correctly. If the
battery charger operates correctly, a battery error may have occurred.
• If the CHARGE lamp is flashing slowly, it is in standby mode and charging has temporarily stopped.
Charging stops temporarily and standby mode results when the temperature is outside the range suitable
for charging. Charging resumes and the CHARGE lamp lights when the temperature returns to the range
suitable for charging. We recommend charging the battery pack in an ambient temperature of between
10°C to 30°C (50°F to 86°F).
161 GB