INSTALLATION SAFETY PRECAUTIONS Installation Safety Precautions CAUTION • Use grill, as purchased, only with LP (propane) gas and the regulator/valve assembly supplied. • This appliance is not for use in or on recreational vehicles • For residential use only. Not intended for commercial use. and/or boats.
USE AND CARE LP (Liquefied Petroleum Gas) WARNING • Is nontoxic, odorless and colorless when produced. For Your Safety , LP gas has been given an odor (similar to rotten For Safe Use of Your Grill and to Avoid Serious cabbage) so that it can be smelled.
Page 5
DANGER CAUTION If ignition does NOT occur in 5 seconds, turn the • NEVER store a spare cylinder under or near the burner controls OFF, wait 5 minutes and repeat the appliance or in an enclosed area. lighting procedure. If the burner does not ignite with •...
Page 6
CAUTION CAUTION NATURAL HAZARD • SPIDERS • Putting out grease fires by closing the lid is not possible. Grills are well ventilated for safety FACT: Sometimes spiders and other small insects climb reasons. into the burner tubes attached to the burner. The •...
StoringYourGrill How To Tell If Meat Is Cooked Thoroughly • Cleancookingsurfaceand trough. •Meat and poultry cooked in the appliance often browns very • WhenLPcylinderisconnectedtogrill,storeoutdoorsinwell- fast on the outside. Use only thawed meat and a meat ventilatedspaceandoutofreachofchildren. thermometer to be sure food has reached a safe internal •...
LIMITED WARRANTY This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after c rrect assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*.
DANGER: If a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Emergencies Possible Cause Prevention/Solution Gas leaking from LP •Mechanical failure due to rusting or •Replace LP cylinder. cylinder. mishandling. Gas leaking between •Improper installation, connection not •...
Troubleshooting (continued) Problem Possible Cause Prevention/Solution Burner(s) will not light PIEZO PUSH-BUTTON AND ROTARY: using ignitor. •Push-button sticks at bottom. •Replace ignitor. •Sparking between ignitor and electrode. •Inspect wire insulation and proper connection. Replace ignitor wires / electrode assembly if insulation is broken. Burner(s) will not •See “GAS ISSUES:”...