Mitsubishi Electric MAC-101HRC-E Operating Instructions Manual page 7

AIR FLOW VELOCITY AND DIR
AIR FLOW velocity and direction can be se-
lected as required.
COOL HEAT
AUTO AUTO
ON/OFF TEMPERATURE
DOWN
COOL/HEAT
FAN VANE
RESET
I
To change the AIR FLOW velocity,
press the
Each time the button is pressed, the fan speed is
changed in sequence:
•
Use the
•
If the operating sound of the air conditioner disturbs
your sleep, use the
F
I
To change the AIR FLOW blowing di-
rection vertically, press the
Each time the button is pressed, the angle of the
horizontal vane is changed in sequence:
(2) → → → → →
SWING OPERATION
UP
Use the swing operation for the air flow to reach all cor-
ners of the room.
Recommended horizontal
vane range
Use the AUTO position usually.
Use position (1) or
COOL mode and use positions
(3) to (5) in the HEAT mode
when adjusting to your require-
ments.
NOTE
I In the cooling operation, when the air conditioner is
operated with setting the horizontal vane to
(5) for 1 hour, the AIR FLOW direction is automati-
cally set to horizontal to prevent condensed water
from dropping.
I Adjust the vertical AIR FLOW direction using the re-
mote controller. If the horizontal vane is moved manu-
ally, it may cause trouble.
I In the heating operation, if the air flow temperature
is too low or when defrosting is being done, the hori-
zontal vane position is set to
FAN
button.
(Low) → → → → →
(High) → → → → → AUTO
(High) notch to cool/heat the room more.
(Low) notch.
(3) → → → → → (4) → → → → → (5) → → → → → (SWING) → → → → → AUTO
COOL
(2) in the
HEAT
(1).
(Med.) → → → → →
VANE
button.
(1) → → → → →
1
2
3
4
5
(4) or
4