Remote controller (How to set the batteries)
Remove the back lid and insert
batteries. Then reattach the back
Insert the minus pole of the batteries first.
Check if the polarity of the batteries is cor-
Handling of the remote controller
The range that the signal can reach is about 20 feet when the remote controller is pointed at the front of
the indoor unit.
When a button is pressed, one or two beeps will be heard from the indoor unit. If no sound is heard,
Use the remote controller carefully.
If it is dropped, thrown or it gets wet, the remote controller may not operate.
When installing on a wall, etc.
Install the remote controller installation case in a position where the signal reception sound (beep) can
be heard from the indoor unit when the
Reference for replacing batteries
When the indoor unit does not respond to the signal from the remote controller, or the display becomes
dim, replace the batteries with new ones (size AAA).
Though both alkaline batteries and manganese batteries can be used, alkaline batteries are recom-
mended because their service life is longer than that of manganese batteries.
The service life of an alkaline battery is about 1 year.
However, a battery which the time limit is approaching may be exhausted soon. The recommended
usable time limit is indicated (month/year) on the bottom of the battery.
Replace the 2 batteries with new ones of the same type.
Do not use rechargeable batteries.
To prevent liquid leakage, take out all batteries when the remote controller is not going to be used for a
Dispose of exhausted batteries in the correct manner.
Refer to OPERATING INSTRUCTIONS attached to the air conditioner for details.
I If the RESET button is not pressed, the remote con-
troller may not operate correctly.
Insert the minus pole
of the batteries first.
button is pressed.
Press the RESET button.
a thin stick.