Monessen Hearth IRVF2T Installation, Operation And Maintanance Manual page 14

I
NSTALLATION AND
Danger: Excessive torque
(twisting) on the inlet fitting of this
heater may cause gas leaks at
one or more of the fittings inside
the heater.
12
53D9012. Rev 1 03/03
A
DJUSTMENT
4. Mark locator points on wall; remove template and drive wall-mount
anchors through the locator points and into the wall as shown by
Figure 5.
FLAT SURFACES OF ANCHOR BLADES
MUST BE PARALLEL TO THE FLOOR. MUST BE PARALLEL TO THE FLOOR.
DO NOT INSTALL ANCHOR WITH FLAT
SURFACES OF BLADES PERPENDICULAR SURFACES OF BLADES PERPENDICULAR
USE HAMMER TO DRIVE ANCHOR INTO WALL. USE HAMMER TO DRIVE ANCHOR INTO WALL.
NOTE: ANCHORS ARE FOR USE IN HOLLOW NOTE: ANCHORS ARE FOR USE IN HOLLOW
WALLS (WALL AREA BETWEEN STUDS). DO WALLS (WALL AREA BETWEEN STUDS). DO
NOT DRIVE ANCHORS INTO WALL STUDS. NOT DRIVE ANCHORS INTO WALL STUDS.
5. Insert mounting screws into anchors and turn each screw until
back of screw head is touching front face of anchor, then back
each screw out of its anchor 1/16 inch.
6. Remove the two front panel screws and then remove the front
panel from the heater by pulling the lower portion of the front panel
up and away as shown by Figure 6.
F 6
IGURE
FRONT FRONT
PANEL OF PANEL OF
HEATER HEATER
FRONT PANEL FRONT PANEL
SCREWS SCREWS
LOWER LOWER
MOUNTING MOUNTING
SCREWS SCREWS
TO THE FLOOR.
NOTE: NOTE:
FOR CLARITY, INTERNAL COMPONENTS FOR CLARITY, INTERNAL COMPONENTS
OF HEATER NOT SHOWN. OF HEATER NOT SHOWN.
F 5
IGURE
BACK SURFACE OF ANCHOR
FACE SHOULD BE TOUCHING WALL FACE SHOULD BE TOUCHING WALL
WHEN PROPERLY INSTALLED.
KEY-HOLE SLOTS KEY-HOLE SLOTS
FOR ANCHOR SCREWS. FOR ANCHOR SCREWS.
STANDOFFS STANDOFFS
OPENING IN BOTTOM OF HEATER OPENING IN BOTTOM OF HEATER
FOR THROUGH-THE-BOTTOM FOR THROUGH-THE-BOTTOM
GAS SUPPLY CONNECTION. GAS SUPPLY CONNECTION.
(ON SOME HEATERS THIS (ON SOME HEATERS THIS
OPENING IS ON OPPOSITE SIDE.) OPENING IS ON OPPOSITE SIDE.)