Product Overview - Cisco BR1400 Deployment Manual

40-bit and 128-bit WEP encryption
802.1x and LEAP
AAA Radius Server support
Enhanced Encryption Features like TKIP,MIC.
• Voice support for P2P configurations.
• Support for Cisco IP-based protocols like TCP, UDP, TFTP, FTP, ARP, ICMP, CDP,
SNMP, RADIUS, TACACS, SNTP, Telnet and NTP.
• Network management support via three interfaces: SNMP, Web Interface, Telnet/CLI.
• Support for Cisco View network management system.
• IP Address Management, supporting DHCP client/server and DNS client/server
functionality
• Provides diagnostic and statistics information, using any of the management interfaces.
• Installation Mode for aligning the antenna and setting up the ODU at the outdoor site.

2.1 Product Overview

The system consists of a weather proof wireless bridge, a Power Injector- LR, a Power Adaptor,
a grounding block at the building entrance and optionally external antennas. The Bridge and the
external antennas, if used, are installed outdoors. The grounding Block is installed at the building
entrance and the Power Injector LR and DC power supply are installed indoors. The overall
System block diagram is shown in the Figure below.
Schematic of Typical Bridge Installation
Figure 4.
2.1.1 Wireless Bridge
The BR1400 wireless bridge includes all the RF and Digital Radio circuitry including four external
interfaces:
1. A pair of 75 ohm F-type coaxial connectors for Power Injector LR interface functioning as
100 Mbps Ethernet communication port and DC power input.
2. Radio interface, which includes a directional captive antenna or an N-type RF connector
for a remote antenna.
Copyright © 2004 Cisco Systems, Inc. All rights reserved.
Page 7 of 53