Pairing The Wireless Subwoofer With The Main Unit; Basic Operation; Standby/On; Select Modes - Teac SB303 User Manual

Pairing the Wireless Subwoofer with the Main Unit

Automatic pairing
The subwoofer and soundbar will automatically pair when both units are plugged into the mains
sockets and turned on. No cable is needed for connecting the two units.
• When the subwoofer is pairing with the main unit, the Pair Indicator will flash.
• When the subwoofer is paired with the main unit, the Pair Indicator will light up.
NOTE:
- Do not press the Pair button on the rear of the subwoofer, except for manual pairing.
- If the automatic pairing fails, pair the subwoofer with the main unit manually.
Manual pairing
1. Ensure that all the cables are well connected and the main unit is in Standby mode.
2. Press and hold the Pair button on the rear of the subwoofer for a few seconds. The subwoofer
will enter the pairing mode and the Pair Indicator will blink quickly.
/SOURCE button on the main unit or the
3. Press the
the main unit on.
4. After the wireless connection succeeded, the Pair Indicator will light up.
5. If the Pair indicator blinks, the wireless connection has failed. Unplug the cable of the
subwoofer and then reconnect the main cable after 3 minutes. Repeat step 1 ~ 4.
NOTE:
• If the wireless connection fails again, check if there is conflict or strong interference (for
example, interference from an electronic device) around your location. Remove these conflicts
or strong interferences and repeat the above procedures.
• The subwoofer should be within 6m of the soundbar.
• If a TV or an external device is connected, the main unit and the subwoofer will switch on
automatically when the TV or the external device is switched on.
• If the main unit is not connected with the subwoofer and it is in On mode, the POWER Indicator
will flash. Follow step 1 ~ 4 above to pair the subwoofer to the main unit.

Basic Operation

Standby/ON

When you first connect the unit to the mains socket, the unit will be in STANDBY mode.
- Press to switch the unit ON.
- Press again to switch the unit back to STANDBY mode. The POWER indicator will light up red.
- Disconnect the mains plug from the mains socket if you want to switch the unit OFF
completely.

Select Modes

Press the SOURCE button repeatedly on the unit or on the remote control to switch between
AUX, MP3 LINK, OPTICAL and BLUETOOTH modes.
button on the remote control to switch
10