Table of Contents
Advertisement
10. Remove the diskette or CD from the drive. The Remote Supervisor Adapter
11. Continue with "Setting up point-to-point protocol" on page 23.
22
xSeries 450: User's Guide
If the serial port is shared with the operating system, it is dedicated to
the Remote Supervisor Adapter only while the server is turned off or
during POST. The port is returned to the operating system after POST
completes. You can view the port using the operating system or any
application. The Remote Supervisor Adapter takes over the port from
the operating system only when information about a critical event is
received. The Remote Supervisor Adapter dials out and transmits an
alert and keeps the port dedicated until the server is restarted. The
port is no longer available to the operating system or applications.
Parity The default is None.
Stop Bits
The default is 1.
Note: The data bits value is preset to 8 and cannot be changed.
For detailed information about the serial port and modem settings, see the
Remote Supervisor Adapter User's Guide on the IBM xSeries Documentation
CD.
6. If you made changes to the serial port settings, press F6 to apply the change.
7. Press Esc to return to the Configuration Settings window.
If you need to set up point-to-point protocol, go to "Setting up point-to-point
protocol" on page 23.
8. Press Esc to return to the Utility program main window.
9. Use the arrow keys to select Exit Utility from the menu, or press Esc to close
the Utility program.
restarts automatically.
Advertisement
Table of Contents
