Page 2
Copyright Notice This document and product is copyrighted, August 1998, by ICP Electronics Inc. All rights are reserved. No part of this manual may be reproduced, copied, or translated without prior notice to ICP Electronics Inc. The information provided in this document is for reference only. We do not assume any responsibility arising out of the application of the products.
1.1 General Information 1.2 Product Specifications 1.3 Dimensions Chapter 2 System Setup 2.1 The Front Panel of Rack-314A 2.2 Removing the chassis cover 2.3 Disk Drives Installation 2.4 Replacing the Filter 2.5 The Card Clamp & Backplane Installation Appendix A...
ACE932T, ACE925T, ACE925C, ACE-916V and ACE-935A). Specially equipped with Keyboard Port on front and rear side for easy access. Rack-314A will withstand shock, vibration, dust and wide range of temperature in Industrial environments. A lockable door protects drives and switches from unauthorized misuse and particle.
Power Supply Optional Power Supply for the Rack-305A are: ACE-932T/935AI/925C/916V For the DC input Power Supply, you may choose: ACE-932T, ACE-925T, ACE-925C or ACE-916V. Working Environment - Operating Temperature : 0~50°C - Relative Humidity 5~95% Relative - Vibration 5-17Hz, 0.1” double amplitude displacement 17-640Hz, 1.5G acceleration peak to peak - Shock 10G acceleration peak to peak...
Chapter 2 Installation Procedure The following set up procedures are provided to assist you in installing the system unit, please follow the steps below: 2.1 The Front Panel of Rack-314A RESET SWITCH KEYLOCK FILTER COVER POWER LED EXT.KEYBOARD HD-LED2...
2.2 Removing the chassis cover The cover is mounted by 6 screws at each side and the top of the chassis, remove them and slide the cover to the rear of the chassis. Figure below shows how to remove the chassis cover.
2.3 Disk Drives installation 1. Open the disk drive door in the front panel 2. Remove the disk drive bay 3. Attach the FDD to the bracket with four screws and connect FDD cable & power cable to the FDD. 4.
2.4 Replacing the Filter The filter of the Rack-305A is located at the front end of the chassis. The filter should be removed and cleaned at least once a month to achieve optimum performance. The filter can be removed simply by turn the key-lock to the counter clock-wise direction.
2.5 The Backplane & Card Clamp Installation To install the backplanes in the chassis, remove the clamp panel first, then put the backplanes inside the chassis and screw it. Figure below illustrates how to install the backplanes on the Rack-314A.
APPENDIX A PASSIVE BACKPLANES 0.00 MODEL:PX-14S VER:E 165.33 175.39 255.58 264.39 PX-14S ACE-932A POWER SUPPLY Brown Brown Blue Black White Blue Black White...