Whirlpool DISHWASHER User Instructions page 9

OPTION SELECTIONS
OPTIONS
Dries dishes with heat. This option, with the use of
rinse aid, will provide the best drying performance.
Plastic items are less likely to deform when loaded in
the top rack. Use Heat Dry for optimum dry
performance, Turn the Heat Dry option off for air dry.
Runs dishwasher at a later time. Select a wash cycle
and options. Each time you press the delay button it
will display the next available delay time. Press
DELAY. Press START/RESUME. Close door firmly.
NOTE: The dishwasher remembers the last Delay
you selected. To reset the delay time to something
other than what is displayed, continue to press the
Delay button until the desired delay time is reached.
NOTE: Anytime the door is opened (such as, to add
a dish); START/RESUME must be pressed again to
resume delay countdown.
Avoids unintended use of dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold SANI RINSE/CONTROL LOCK or DELAY (depending on model) for 3 seconds. Control Lock
light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button while your
dishwasher is locked, light flashes 3 times. Dishwasher door can still be opened/closed while the controls are locked.
To turn off Lock, press and hold SANI RINSE/CONTROL LOCK or DELAY (depending on model) for 3 seconds. Light turns off.
NOTE: If your model requires you to press and hold DELAY to lock controls, Control Locked LED will be on or off to indicate
whether Control Lock is active or not.
CONTROLS AND CYCLE STATUS
CONTROL PURPOSE
Press to start or resume a wash cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume button LED flashes. Cycle will
not resume until door is closed and START/RESUME is pressed.
NOTE: If Start/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing
START/RESUME. If door is not closed within 3 seconds, Start/Resume button LED will flash, an audible tone will
be heard (on some top control models), and cycle will not start.
Press to cancel wash cycle.
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely. Press
and hold START/RESUME for 3 seconds.
To follow progress of
your dishwasher cycle.
NOTE: Indicators shown
are not available on all
models.
CAN BE
SELECTED
WITH
Sensor
Heavy
Normal
Soak & Clean
Available with
any cycle
COMMENTS
The Clean indicator glows when a cycle is finished.
If you select Sani Rinse option, when cycle is finished, the "Sanitized" indicator glows.
If your dishwasher did not properly sanitize your dishes, the light flashes at the end of
the cycle. This can happen if the cycle is interrupted, or water could not be heated to
required temperature. The light goes off when you open and close door or press
CANCEL.
ADDED TIME
WHAT IT DOES TO CYCLE
Uses heating 0:08 to 0:46
element to speed
drying times.
Heat Dry option
defaults to On
when any cycle is
selected except
for 1-Hour Wash.
Delays start of a 0:00
cycle up to
.
24 hours
ADDED
WATER
GALLONS
(LITERS)
0
0
9