Table of Contents
Advertisement
Wireless remote controller kit
3) Remove a screw, move the side panel toward you (direction of arrow), and then remove the side panel.
(Fig. D)
4) Lap the end of flat head screw driver with vinyl tape, and forcedly insert it into the groove at the side under
circle mark on the cover. (Be careful not to damage the panel.) (Fig. E)
5) Pass the lead wire through the panel, and install
the signal receiving unit to the panel hole. (Projection of the signal receiving unit is fixed by the panel hole.)
6) Fix the lead wire of the signal receiving unit to the cord clamp which fixes the cables of the louver motor.
(Fig. F)
7) Install the side panels, with screws as original.
8) Put the lead wire from the signal receiving unit along cables of the louver motor and others, and then fix it
with the cord clamp. (Fig. G)
∗ It's connected to a connection of Remote control wire through a hole for Remote control wire. (Fig. H)
9) After all connections have been made, install wire guard and suction grill before doing the "TEST RUN".
Fig. D
Panel
Suction grille
Fig. F
Signal receiving unit
Fig. H
Hole for signal receiving unit wires
English-3
Fig. E
Side panel
Screw
Fig. G
Cord clamp
High voltage wires
and earth line
NOTE 1
Avoid to twist cables of the sensor with the
power cables, otherwise a malfunction is caused.
∗ For cabling and TEST RUN, refer to "HOW TO
Lead wire from the
signal receiving unit
PERFORM CABLING OF SIGNAL RECEIVING
UNIT" of these sheets and "TEST RUN" of the
Installation manual attached to the indoor unit.
3
Installation Manual
Flat head screw driver
(Lap it with vinyl tape.)
Vinyl tape
Cover
Insert it into groove at
the side under circle
mark on the cover.
Cord clamp
Cord clamp
Advertisement
Table of Contents
