Hotpoint LFT 114 Instruction Booklet page 5

Sink Waste System
• before connecting the drain hose, remove any
internal restrictions; this will prevent a build up of
debris which could cause a blockage
• remove any restrictions from the waste spigot and
ensure that the sealing bung is removed
• the hose should be routed, such that it is raised
to a minimum height of 800mm (31/2”).
Ensure the sink outlet pipe has a minimum
diamtere of 32mm.
• If fitting an under sink waste disposal unit, cut out
the membrane, bung or blanking plug.
Ensure the drain hose is securely attached, to
prevent it coming away while the machine is in
use and causing a flood.
• Untie the end of the
GREY drainage hose from
the rear of the appliance.
• Reposition the ‘Hooked
End Support’ as required
along the GREY drainage
hose.
To ensure floods do not occur, the dishwasher:
- is provided with a special system which blocks the
water supply in the event of anomalies or leaks from
inside the appliance.
Some models are also equipped with the
supplementary safety device New Acqua Stop
which guarantees anti-flooding protection even in the
event of a supply hose rupture.
Under no circumstance should the water inlet hose
be cut as it contains live electrical parts.
The Company shall not be held responsible for
any incidents that occur if these regulations are not
observed.
*
Only available in selected models.
*
*
,
EN
5