Initial Settings; Adjusting Initial Settings; Setting The Clock; Turning The Clock Display On Or Off - Pioneer DEH-1650 Operation Manual

Initial Settings

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1 Press SOURCE and hold until the unit
turns off.
2 Press AUDIO and hold until clock ap-
pears in the display.
Press AUDIO repeatedly to switch between
the following settings:
ClockFM 100 (FM tuning step)AM 9 (AM
tuning step)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down AUDIO until the unit turns off.

Setting the clock

Use these instructions to set the clock.
1 Press AUDIO to select clock.
Press AUDIO repeatedly until clock appears in
the display.
2 Press c or d to select the segment of
the clock display you wish to set.
Pressing c or d will select one segment of the
clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Press a or b to set the clock.
Pressing a will increase the selected hour or
minute. Pressing b will decrease the selected
hour or minute.

Turning the clock display on or off

You can turn the clock display on or off.
% Press CLOCK to turn the clock display
on or off.
Each press of CLOCK turns the clock display
on or off.
# The clock display disappears temporarily
when you perform other operations, but the clock
display appears again after 25 seconds.

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press AUDIO to select FM 100.
Press AUDIO repeatedly until FM 100 appears
in the display.
2 Press c or d to select the FM tuning
step.
Pressing c or d will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Section
07
13
En