Kenwood Nexedge NX-200G Instruction Manual page 13

INSTALLING THE (OPTIONAL) ANTENNA
Screw the antenna into the connector
on the top of the transceiver by holding
the antenna at its base and turning
it clockwise until secure.
INSTALLING THE BELT CLIP
Attach the belt clip using the
supplied M3 x 8 mm screws.
Note: If the belt clip is not installed,
its mounting location may get hot
during continuous transmission or
when left sitting in a hot environment.
Do not use glue which is designed to prevent screw loosening when
installing the belt clip. Acrylic ester, which is contained in these
glues, may crack the transceiver's back panel.
Optional
antenna
Belt clip
M3 x 8 mm
screws
3