How To Run A Wash Cycle; Daily Use - Zanussi ZWQ 6100 User Manual

How to run a wash cycle?

Using for the first time
• Ensure the electrical and water connec-
tions comply with the installation in-
structions.

Daily Use

Loading washing
• Open the lid of the
appliance.
• Open the drum by
depressing the
locking button A:
The two shutters
unlock automati-
cally.
• Load the washing,
close the drum and the lid of your washing
machine.
Warning! Before closing the lid of your
appliance, ensure that the drum is properly
closed :
• When the two shutters are closed,
• locking button A released.
Proportioning of detergents
Pour the amount of washing into the washing
and prewash
selected the "prewash" option. Pour fabric soft-
ener into the compartment
Selection of desired programme
Turn the programme selector to the required
programme. The "Start/Pause"
flashes green.
If you turn the programme selector to another
programme while a cycle is in progress, the ap-
pliance will ignore the new selected pro-
gramme. "Err" flashes and the "Start/Pause"
pushbutton flashes red for a few seconds.
Selecting the spin speed
Press the "Spin"
speed.
The maximum spin speeds are :
www.zanussi.com
A
compartments if you have
if necessary.
pushbutton
button to change the spin
• Remove the polystyrene insert and all
other items inside the drum.
• Run an initial wash cycle at 90°C, with-
out any washing but with detergent to
clean the water tank.
for Cottons, Jeans : 1200 rpm (ZWQ 6120),
1000 rpm (ZWQ 6100), for Handwash, Wool :
1000 rpm (ZWQ 6100), 900 rpm (ZWQ
6120), for Synthetics, Sport : 900 rpm, for Deli-
cates, Curtains : 700 rpm.
Rinse hold
By selecting this function the water of the last
rinse is not emptied out to prevent the fabrics
from creasing.
At the end of the programme, if you have selec-
ted "Rinse hold"
"Spin" or "Drain"
the cycle and empty the water.
Selecting options
You must select the different options after se-
lecting the programme and before pressing the
"Start/Pause" pushbutton (see "Programme
table"). Press the desired button(s) ; the corre-
sponding lights come on. If pressed again, the
lights go out. If one of the options is not com-
patible with the selected programme, "Err"
flashes on the display and the "Start/Pause"
pushbutton flashes red.
"Prewash" option
The appliance runs a prewash at 30°C max.
"Quick" option
The washing time will be reduced depending
on the programme selected.
"Economy" option
This option allows you to choose a lower tem-
perature programme which is as effective as a
higher temperature wash programme.
, you then need to select a
programme to finish
5