Table of Contents
Advertisement
Creating a Sensor Schedule (Example)
Sensor inputs can be programmed to instantly trigger recording on one or more camera channels when an alarm event occurs.
Note You must first associate the software sensors with the sensors. See the Hybrid Sensor Setup section of this manual for more
detail.
This schedule example will be as follows:
SUN-SAT (12AM – 11:59 PM) cameras 1 and 2 will be activated by Sensor 3 and Sensor 4.
1.
Select Sch01 in the Schedule Number list.
2.
Click the Single Selection Mode button to enable Multi Selection Mode.
3.
Select Sun, Mon, Tue, Wed, Thu, Fri, and Sat.
4.
In the Sch01 row, click and drag your mouse to select the entire row.
5.
Click 1 and 2 in the Camera section repeatedly until a red S (sensor) appears.
6.
Click 3 and 4 in the Sensor section.
7.
Click Apply to save.
62
Advertisement
Table of Contents
