Table of Contents
Advertisement
Using the Graphical PTZ Controller
1.
In the Display screen, click Pan/Tilt.
2.
Click the viewing area of the PTZ camera you want to control.
3.
Use the Arrow buttons to control the direction of the PTZ camera.
4.
To select a new camera, click the video display of a different camera
on the Display screen display.
Note Eight directions are available only for select cameras. Only four of the
PTZ Control buttons work for all protocols (UP, DOWN, LEFT, RIGHT).
Note The Advanced menu panel on the graphical PTZ controller can be used
to set PTZ preset positions (on supported cameras), as well as move to
presets up to 254.
5.
To exit the Graphical PTZ Controller, click Pan/Tilt again.
Note To access the OSD menu on Toshiba PTZ cameras, type 95 in the
Preset Menu field, and then click Set.
Using the On-Screen Compass
1.
On the Live screen, click Setup.
2.
Click PTZ Setup.
3.
Select the Camera Channel of the PTZ camera you want to enable Onscreen Compass control for.
4.
In the General tab, select Onscreen Compass.
5.
Click Apply.
6.
Close the Setup window to return to the Live screen.
7.
Click Pan Tilt.
8.
Control the PTZ camera by clicking and dragging the mouse on
the screen in the desired direction.
Note A green line will appear to show the direction in which the PTZ
camera will move. The shorter the line, the less the PTZ will move.
The longer the line, the more the PTZ will travel in the specified
direction.
52
Arrow buttons
Current
camera
channel
Move to
preset
positions 1-10
Open & close
the Advanced
Controls panel
Open the camera
menu
Set presets, and
move to presets
11-254
Advertisement
Table of Contents
