Linking (Pairing) The Headset To The Multi-Adapter - Jabra BT200 User Manual

3. While charging, the indicator light (BLUE LED) on the headset and multi-adapter are
lit, and will remain lit, until both the headset and multi-adapter are fully charged. (The
LED will only turn on if the headset is correctly inserted into the multi-adapter.)
4. Charge the headset and multi-adapter for approximately 2 hours, or until both the
indicator lights go out.
5. You can now remove the headset from the multi-adapter and it will be ready to use.
If you remove the headset from the multi-adapter (with the power supply plugged in) the
headset will automatically turn on (standby mode). If there is an incoming call when the
headset is in the multi-adapter then you can answer the call as described in section
'making and receiving calls' .
Low Battery Warning:
The headset needs re-charging when you hear three rapid high tones through the
headset's speaker at 30-second intervals, and see the LED flash quickly 3 times every 3
seconds. Once the low battery warning indicators start you have 3-5 minutes of talktime
left and you will then need to follow the above steps 1-4.
14
Linking (Pairing) the Headset to
the Multi-adapter
Pairing creates a unique wireless link between two Bluetooth devices – such as the JABRA
BT200 headset and multi-adapter. You should NOT have to pair your headset and multi-
adapter – they have already been paired in the factory for you. If you want to use a
different JABRA multi-adapter or headset, then please follow the steps below:
1. Ensure that the main power adapter is not plugged in.
2. Ensure that the JABRA BT200 is switched OFF.
3. Using the stylus supplied, press down on the stylus switch (see Using the Stylus
Switch section) for 6 seconds until the multi-adapter indicator light stays lit. Then
Release. (Note that the indicator light will flash during the 6 seconds – but keep
pressing until on constant.)
4. Without delay, press the multi-function on/off button on the headset for 6 seconds
until it's indicator light stays on constant. Then release the button.
5. After a short period, both the indicator lights will flash in standby mode (every 3 seconds).
6. The headset and multi-adapter are now paired.
You will not need to repeat this process in the future because the headset and the
multi-adapter are now paired.
15