Jabra BT200 User Manual page 10

3. Place the headset in the desired wearing style.
4. Use the phone's keypad to initiate the voice dialling.
5. A short tone will prompt you to say the name of the person you wish to call (as
entered in the phone's voicedial phonebook directory). Speak the voice 'tag' name.
6. The phone automatically dials your selection, and you see the details of the call on the
phone screen.
7. When connected you are free to communicate normally via the headset.
d) Ending a call from the Headset
To end a call when wearing the headset - press the headset's Multi Function Button.
Or you can simply end the call from the phone keypad.
e) Receiving/Answering a Call
Any of three methods can be used to answer a call. In each way you must first press
the multi-function button on the headset to put it into 'active' mode. During active
mode the LED will flash every second.
1. Headset First
Briefly press the multi-function button to make the headset active – then answer the
call from the phones keypad in the usual way.
18
2. Keypad First
Answer the call as usual by using the phones keypad. In this case your can then
follow instruction in the section Transferring a Call.
3. From the Multi-Adapter
If there is an incoming call and your headset is in the multi-adapter then you must:
•
Disconnect the power adapter (if plugged-in)
•
Remove the headset from the multi-adapter, and make sure it is switched on.
•
Press the headset multi-function button to put the headset in active mode.
•
Answer using the phone's key pad.
f) Transferring a Call
To transfer a call from the phone to the headset, briefly press the headset Multi-
function button which will start the active mode. Plug the jack of the multi-adapter
into your phones headset socket.
To transfer a call from the headset to the phone, press the multi-function button
which will place the headset in standby mode. Then remove the jack from the headset
socket on your phone.
19