Advertisement
TIPS & SOLUTIONS
To prolong battery life:
• After you've ended a call using your phone's keypad, always remember to place the
headset in Standby mode by pressing and releasing
• Dock the headset firmly in its multi-adapter when not in use.
If you press and release
If FreeSpeak becomes unpaired, it will not respond to the
occur when you first receive the product or when you hold the
the product.
To "pair" the headset with the multi-adapter:
1. Ensure headset is off.
2. Press
until you see a solid blue light on the headset, then release.
3. Use the stylus to press down on the
stylus switch until you see a solid blue
light on the multi-adapter, then
release.
Important: Once pairing is complete,
lights on both the headset and multi-
adapter will begin flashing (Standby
mode).
If you hear an echo of your voice – You may need to adjust
microphone levels.
To reduce the echo:
1. Lower the volume of your phone and headset.
2. If echo persists, put FreeSpeak in Active mode.
3. Use the stylus to press down on the stylus switch (as shown above) until you see a solid
c
blue light on the multi-adapter. Continue to press down until you see/hear 1, 2, or 3
z
flashes/beeps, then release. The last number of flashes/beeps corresponds to the final
c
setting.
4. Repeat step 3 to cycle between different microphone levels.
and the headset stays in Standby mode:
Stylus
Switch
Stylus
when not in use.
button. In rare cases, this may
button too long while using
Multi-adapter
Flashes or
Microphone Level
Beeps
High (default)
1
Medium
2
Low
3
Advertisement
