Jabra 14201-32 Manual

Jabra Link 14201-32
How to connect my Jabra GN9120 EHS / GN9125 EHS with
Nortel IP 1120E, 1140E, 1150E, 1165E

Prerequisite:

Jabra GN9120 EHS + Jabra LINK 14201-32 (from FW 2.2.0)
Jabra GN9125 EHS + Jabra LINK 14201-32 (from FW 2.2.0)
In combination with one of the following phones:
Nortel IP 1120E
Nortel IP 1140E
Nortel IP 1150E
There is a minimum revision level (UNIStim 5.2) needed when using our
EHS adapter on Nortel 1140e with CS2100 server. The CS1000 is OK with
3.1 or greater. It can be downloaded from http://support.nortel.com.

Connection:

1. Connect the 1-sided end (USB plug) of the EHS adapter with the USB
socket on your phone.
2. Insert the RJ9 plug into the socket identified with the "phone" symbol
and the RJ45 plug into the socket identified with "AUX" on the base.

EHS setup:

The Jabra GN912x must support and be set up on DHSG EHS.
Proceed as follows to check the EHS installed:
1. Place the headset on the base and press the PLUS and MINUS buttons
simultaneously for approx. 6 seconds until the online display on the
https://www.jabra.co.nz/supportpages/jabra-link-14201-32/14201-32/faq/50e3d2d4-4986-
4d9b-b283-11c16b2ceb5f
12/01/2022 22:29
Page 1 of 4