Honda CRF50F 2004 Owner's Manual page 101

Wheels
Take care to prevent getting grease, oil, or dirt
on the brake shoe surfaces. This can cause poor
brake performance or rapid brake shoe wear
after reassembly.
Installation
1. Reverse the removal procedure. Make sure
the lug ( ) on the fork leg is located in the 5
slot ( ) in the brake panel. 6
2. Torque the axle to:
35 lbf·ft (47 N·m , 4.8 kgf·m)
3. Check front brake adjustment (page
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
92
Servicing Your Honda
85 ).