Changing The Fuse; Mounting On Your Dashboard - Garmin Nuvi 500 Series Owner's Manual

Changing the Fuse

CauTiOn: When replacing the fuse,
do not lose any of the small pieces, and
ensure they are put back in the proper
place.
If your unit will not charge in your
vehicle, you might need to replace the
fuse located at the tip of the vehicle
adapter.
1. Unscrew the black, round end piece,
and remove it.
2. Remove the fuse (glass and silver
cylinder), and replace it with a 3 A
fast‑blow fuse.
3. Ensure that the silver tip is placed in
the black end piece. Screw on the
black end piece.
nϋvi 500 Series Owner's Manual
Autogood products internet store http://130.com.ua
End
piece
Silver tip
Fuse
Mounting on Your
Dashboard
Use the enclosed mounting disk to mount
your unit to the dashboard and comply
with certain state regulations.
CauTiOn: The permanent mounting
adhesive is extremely difficult to
remove after it is installed.
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover from
the top of the disk.
5. Place the suction cup mount on top of
the disk. Flip the lever down (toward
the disk).
Appendix