Identification Of Components; Pre-Operation Check - Kipor KDP20 Owner's Manual

2. IDENTIFICATION OF COMPONENTS

Read all labels, safety instructions and precautions described in this Owner's Manual carefully.
These labels warn you of potential hazards that can cause serious injury.
If a label comes off or becomes hard to read, contact your authorised dealer for a replacement.
FRAME
SERIAL NUMBER LOCATION
The serial number identifies the
particular water pump and is
important when ordering spare
parts for any warranty or
service maintenance.
The serial number can be found
stamped on the engine block
below the oil filler dipstick.
THROTTLE LEVER
Oil Filler Dipstick
Serial Number
4

3. PRE-OPERATION CHECK

•
Be sure to check the water pump is on a firm level surface with the engine stopped.
STEP 1.
Check the engine oil level.
•
Using a non-detergent oil or 2-stroke engine oil could shorten the engine's service life.
It is recommended to use SAE 10W-30 Grade engine oil.
Can use Part No. 06.2251 Jamec Pemsmall engine oil 1L.
Only use a high-detergent, premium quality 4-stroke engine oil, certified to meet or exceed U.S.
automobile manufacturer's requirements for API Service Classification for diesel engines
CC/CD/CE/CF.
To Check Oil Level -
Remove the oil filler dipstick, and wipe the dipstick with a clean rag.
Insert the oil filler dipstick into the filler hole without rotating it.
If the oil level is below or at the lower end of the dipstick, refill with the recommended oil up to the
upper level mark. Tighten the oil filler dipstick.
Oil Capacity:
KDP20/E 0.75L
KDP30/E 1.10L
KDP40/E 1.62L
5