Advertisement
SERVICE MANUAL
All information, illustrations, directions and specifications included in this publication are
based on the latest product information available at the time of approval for printing.
KIPOR POWER CO., LTD, reserves the right to make changes without incurring any obligation.
No part of this publication may be reproduced without written permission.
For more information contact Customer Service on
1300 555 197
Distributed by
PRIMUS AUSTRALIA PTY LTD
Bundoora VIC 3083
www.kipor.com.au
www.primusaustralia.com.au
Advertisement
Table of Contents
Related Manuals for Kipor KDP20
Summary of Contents for Kipor KDP20
- Page 1 All information, illustrations, directions and specifications included in this publication are based on the latest product information available at the time of approval for printing. KIPOR POWER CO., LTD, reserves the right to make changes without incurring any obligation. No part of this publication may be reproduced without written permission.
- Page 2 PREFACE Thank you for purchasing a Kipor Diesel Water Pump. This manual covers the operation and maintenance of model KDP20/E, KDP30/E & KDP40/E High Volume Water Transfer Pumps. All information in this publication is based on the latest product information available at the time of approval for printing.
-
Page 3: Table Of Contents
CONTENTS 1. SAFETY INSTRUCTIONS To ensure safe Operation - 1. SAFETY INSTRUCTIONS • This water pump is designed to give safe and dependable service if operated according to instructions. Read and understand the Owner's 2. IDENTIFICATION OF COMPONENTS Manual before operating the water pump. Failure to do so could result in personal injury or equipment damage. -
Page 4: Identification Of Components
Tighten the oil filler dipstick. The serial number identifies the Oil Filler Dipstick Oil Capacity: particular water pump and is important when ordering spare KDP20/E 0.75L parts for any warranty or KDP30/E 1.10L service maintenance. KDP40/E 1.62L Serial Number... - Page 5 Avoid getting dirt, dust or water in the fuel tank. After refuelling, tighten the fuel tank cap securely. the rubber seal is seated corrected onto the suction port. Install the strainer on the other end of the suction hose with a hose band. Tighten securely. Fuel Tank Capacity: KDP20/E 2.5L KDP30/E 3.5L RUBBER SEAL KDP40/E 5.5L •...
-
Page 6: Starting The Engine
4. STARTING THE ENGINE 4. STARTING THE ENGINE cont. Step 6. Move the throttle lever to the desired engine speed position - tighten knob. Before starting the engine: Discharge flow is controlled by adjusting the engine speed. Increasing engine speed will increase Step 1 . -
Page 7: Stopping The Engine
5. STOPPING THE ENGINE 6. MAINTENANCE To stop the water pump move the throttle lever to stop position. Periodic inspection and maintenance are essential to keep the water pump in the best operating condition. IN NORMAL USE: Inspect and service this water pump as scheduled in the table below. Step 1 . - Page 8 Remove the air cleaner cover by loosening the top wing nut. Step 2. Loosen the hex nut that retains the air cleaner element. Engine Oil Capacity: Step 3. KDP20/E 0.75L Remove the foam outer air cleaner element and inspect. KDP30/E 1.1L Inspect the inner paper air cleaner element. KDP40/E 1.62L Step 4.
-
Page 9: Transporting And Storage
6.3 BATTERY SERVICE 7. TRANSPORTING and STORAGE If the water pump is equipped with a battery for the electric start, recharge the battery once To prevent any fuel spillage when transporting or during temporary storage, the water pump should a month to ensure optimum service life of the battery. be secured upright in its normal operating position. -
Page 10: Troubleshooting
8. TROUBLESHOOTING 7. TRANSPORTING and STORAGE cont. When the engine will not start Step 3. Refill the fuel tank? Is there fuel in the tank? Drain the fuel Drain all diesel fuel from the fuel tank into an approved fuel container using a funnel to avoid spilling. -
Page 11: Specifications
To be eligible for warranty service, the product must be purchased in Australia from an authorised Dry weight (kg) 35kg 52kg 69kg Kipor dealer. This warranty applies to the original retail purchaser only, and is not transferable. Overall dimension (mm) 525 x 410 x 515mm 510 x 445 x 550mm 650 x 480 x 600mm The original Proof of Purchase is required.