VuQube VQ1000 Operating Instructions Manual page 9

STEP 1: CHECK SWITCH PROCEDURE (Before satellite acquisition)
1. Disconnect the coax from "SAT IN" on the back of the receiver.
2. Turn on the TV and satellite receiver.
3. On the receiver's remote, press (MENU, 6, 1, 1) to
display the signal meter screen.
4. Highlight Check Switch and press select.
Note: Some receivers may prompt you to select
check switch a second time to initiate the test.
5. Make sure Superdish and Alternate boxes
are NOT selected.
Note: Not all receivers will display a screen with
options that include superdish and alternate boxes.
6. Highlight Test and press Select.
The receiver will perform a check switch test. (This process will take several minutes.)
7. When test is complete, a screen similar to this should appear.
(Receivers are always changing, and therefore screen graphics may vary.)
If you get a WARNING screen stating you have
fewer satellites than previously detected, with
the option to save the settings, select SAVE
and continue. (You may have to choose SAVE twice.)
8. Highlight OK and press Select to return to the Point Dish Screen.
9. Reconnect the coax to "SAT IN" on the back of the satellite receiver.
10. Go to page 8, step 2, and determine your switching option.
"NO SWITCH DETECTED"
or
"INSTALLED DEVICE UNKNOWN"
or similar
Screen graphics may vary.
Page 7