X11 Wireless Broadband Router
○
3 Checking PC's IP and Connection with the Router
After configuring the TCP/IP protocol, use the ping command to verify if the computer can
communicate with the Router. To execute the ping command, open the DOS window and
ping the IP address of the Wireless Broadband Router at the DOS prompt:
To execute ping command, open the DOS window by clicking on Start -> Run. In the Run
window, type CMD. At the DOS prompt, type the following command:
If the Command window returns something similar to the following:
Then the connection between the router and your computer has been successfully
established.
If the computer fails to connect to the router, the Command window will return the following:
Figure 13
Figure 14
Page 12 of 69
User manual