Philex SLX 27822BMG User Manual

2 way signal booster with digital bypass

Advertisement

27822BMG

Introduction

Special features include:
4G Ready - built-in filter removes interference and channel loss caused by 4G
mobile phone signals
Dedicated inputs for UHF and FM/DAB
Side mounted terminals provide easy cable management
Infra-red by-pass for digilinks
The SLxB series amplifiers are designed to improve
the picture and sound quality of TV and FM/DAB radio
signals and distribute these signals around your home.
All SLxB amplifiers have an integrated by-pass
designed to allow the user to control digital satellite
receivers from a second TV without additional
equipment apart fron a Link device and a digital
satellite or compatible universal remote control.
Please Note: To view output from the satellite RF2
output you will need a TV with an analogue tuner.
Careline: 08457 573 479 - (Local Rate UK only)
2 Way Signal Booster
with digital bypass

USER GUIDE

For added safety the SLxB series has built in short
circuit protection on each individual output. Should
a short circuit be detected the SLxB amplifier will only
shut down the output with the short circuit; the other
outputs will continue to function as normal.
The amplifiers are easy to install and fully automatic in
operation, meaning that no user adjustment is required.
The low running cost permits continuous operation.
Support: www.philex.com/support
Ready

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SLX 27822BMG and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Philex SLX 27822BMG

  • Page 1: User Guide

    2 Way Signal Booster Ready with digital bypass 27822BMG USER GUIDE Introduction Special features include: • 4G Ready - built-in filter removes interference and channel loss caused by 4G mobile phone signals • Dedicated inputs for UHF and FM/DAB • Side mounted terminals provide easy cable management •...
  • Page 2 Installing your amplifier Aerial signal distribution You can choose to boost either TV or radio signals. 1. Connect your UHF aerial downlead (or your FM/ DAB aerial downlead) to the ANT socket on your amplifier. 2. Connect your TVs or FM tuners to either of the SLxB TV1 or TV2 sockets.
  • Page 3 Signal distribution from a Satelllite Receiver Please Note: To view output from the satellite RF2 output you will need a TV with an analogue tuner. 1. Connect your UHF aerial downlead to the aerial Note. To operate your digital satellite receiver from input on your Satellite Receiver.
  • Page 4 Please recycle Alternatively, please visit our technical website at where facilities exist. Check with your Local Authority for recycling advice. www.philex.com/support © Philex Electronic Ltd 2013. v1 www.philex.com Wall Mounting Drilling Template SLx2B Prepare holes 60mm apart...

Table of Contents