JVC CH-X400 Service Manual page 9

Rear slider
1. Position the unit with the front section facing down. Rotate
the third gear located on the back of the main unit in the
direction of the arrow (clockwise).
2. Shift the rear slider in the direction of the arrow and remove it
at the rear slider mounting position (at the widest hole).
Front slider
1. Position the unit with the rear section facing down. Rotate the
third gear located on the bottom of the unit in the direction of
the arrow (clockwise) until the front slider is shifted to the
outermost position.
2. Remove the E-washer securing the front slider to remove the
front slider from the chassis.
Top plate
1. Remove the nine screws (3) securing the top plate.
2. Disconnect the section (e) attached to the rear of the unit,
then lift the top plate slightly.
3. Slide the top plate toward the rear of the unit to remove the
upper rod from the top plate.
3
Top Plate
3
Slide and remove the rod inside
Slide
3
Rod
3
Fig. 17
Can be removed at the stud position
(at the widest hole)
Shift
Fig. 15
Remove the E-washer
Third gear
Fig. 16
After lifting
3
CH-X400/CH-X450
Remove
Third gear
Remove
Fig. 18
e
1-9