JVC CH-X400 Service Manual page 6

CH-X400/CH-X450
Removing the top cover
1. Pull out the dampers, being careful not to damage.
When reattaching a damper, insert your finger to push out the
center of the damper to mount it on the damper shaft, as
shown in Fig. 6-1.
2. Turn the damper spring bracket toward the top at a right angle
as shown in Fig. 7, then push down the lower side of the
damper spring bracket to lift it off.
3. Remove the three fixing screws (3) and (4) on the DIN jack
PCB assembly.
4. Lift the changer unit upward.
5. Remove the damper springs from the mechanism chassis if
required. To reassemble, refer to the diagram below.
Fig. 6-1
Lift the changer unit upward
Fig. 8
Silver
(mechanism side)
How to attach the damper springs
1-6
Apply alcohol to the shaft then
immediately attach the damper. (After
attaching, check that the shaft is
correctly inserted.)
Push out with your
finger before
attaching
Mechanism
Chassis
Red
(magazine side)
Fig. 8-1
Fig. 5
Turn to the top position (at a right angle),
then push down to lift off.
Remove the flexible ribbon
wire if required
Fig 6
Fig. 7
4
4
3
Fig. 9