JVC CH-X400 Service Manual page 21

CH-X400 & CX-H450 Error code
The following error codes can be displayed and stored in up to 3 memories when the KD-MX3000 is used with
the controller. Refer to the KD-MX3000 service manual regarding error code indication.
The error code indication when using the earlier controller is the same as the CH-X99,KD-MK88 and other
12CD changer models.
Generating condition
Tray extension Tray-in switch time out
(Tray-in switch Low, Tray-out switch High)
error
Tray-out switch time out (Tray-in switch High,
Tray-out switch High)
Tray-in switch time out (Tray-in switch Low,
Tray-out switch Low)
MAG-in switch Low to High
Tray-in switch time out (Tray-in switch Low,
Tray retraction
Tray-out switch Low)
error
Tray-out switch time out (Tray-in switch High,
Tray-out switch High)
Tray-in switch time out (Tray-in switch Low,
Tray-out switch Low)
MAG-in switch Low to High
Wait position time out
Lifter raise error
Wait position time out
Wait position time out
Wait position time out
Lifter lower error
Wait position time out
Wait position time out
Play position time out
Chuck error
Play position time out
Play position time out
Unchuck error Wait position time out
Wait position time out
Wait position time out
Eject position time out
Eject error
Eject position time out
MAG in switch time out
Mechanism switch time out
Initialize error
Absolute position time out
Note: The 1st error code is indicated by E1, while the 2nd and 3rd error codes are respectively indicated by
E2 and E3.
CH-1 error code table
Description
Tray stops part way
Tray stops part way
Tray-in switch faulty or other defect
Magazine removed when tray partly
extende
Tray motor inoperative
Tray retraction stops part way
Tray-in switch faulty or other defect
Magazine removed when tray partly r
etracted
Position motor inoperative
Position not stable in fine adjust mode
Other fault
Position motor inoperative
Position not stable in fine adjust mode
Other fault
Position motor inoperative
Position not stable in fine adjust mode
Other fault
Position motor inoperative
Position not stable in fine adjust mode
Other fault
Position motor inoperative
Eject position not attained
Magazine not ejected
Both Tray-in and Tray-out Low
Not stable at absolute position
CH-X400/CH-X450
Error code
E1 03 00 11
E1 03 00 12
E1 03 00 13
E1 03 00 14
E1 03 00 16
E1 03 00 17
E1 03 00 18
E1 03 00 19
E1 02 00 21
E1 02 00 22
E1 02 00 23
E1 02 00 26
E1 02 00 27
E1 02 00 28
E1 02 00 31
E1 02 00 32
E1 02 00 33
E1 02 00 36
E1 02 00 37
E1 02 00 38
E1 02 00 41
E1 02 00 42
E1 02 00 43
E1 03 00 46
E1 03 00 47
1-21