Attaching The Stand; Setting The Tv - Sharp Aquos LC-24LE430X Operation Manual

Attaching the stand

• Before attaching (or detaching) the stand, unplug the AC cord from the AC outlet.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
1
Confi rm the screws supplied with the TV.
Screws ( m 8)
(used in step 2 and 3)
2
Attach the stand neck to the stand base,
insert and tighten the 4 screws into the 4
holes on the bottom of the stand base ( 1 ).
3 Attach the stand neck to rear of the TV,
insert and tighten the 4 screws into the 4
holes on the stand neck. ( 2 )
NOTE
• To detach the stand, perform the steps in reverse
order.

Setting the TV

Connecting the antenna cable
To enjoy a clearer picture, use an outdoor antenna.
VHF/UHF
antenna
VHF/UHF
antenna
75-ohm coaxial
cable (round cable)
(not supplied)
If your outdoor antenna uses a 75-ohm coaxial
cable with a standard DIN45325 plug (IEC 169-2),
plug it into the antenna jack at the rear of the set.
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
• The illustrations used throughout this manual are based on LC-32LE430X.
LC24LE430X_EN.indb 3 LC24LE430X_EN.indb 3
Soft cushion
75-ohm
impedance
converter
300-ohm twin-
(not supplied)
lead fl at feeder
(not supplied)
or
Standard DIN45325
plug (IEC 169-2)
Screw
1
Screw driver
To antenna terminal
If your outdoor antenna uses a 300-ohm twin-
lead fl at feeder, connect a 300-ohm to 75-ohm
impedance converter and plug it into the antenna
jack at the rear of the set.
2
Screw
Screw driver
3
7/19/2011 9:38:05 AM 7/19/2011 9:38:05 AM