Expresscard Problems; Power Failures - Fujitsu Lifebook E752 User Manual

Problem
You have installed a serial,
or USB device. Your LIFE-
BOOK notebook does not
recognize the device, or the
device does not seem to
work properly.
(continued)

ExpressCard Problems

A card inserted in the
ExpressCard slot does not
work or is locking up the
system.

Power Failures

You turn on your LIFEBOOK
notebook and nothing
seems to happen.
Possible Cause
Your device may not have
the correct software driver
active.
Parallel port is set to output
only.
A device may have been
installed while an application
was running, so the notebook
is not aware of its installation.
The card is not properly
installed.
Your software may not have
the correct software driver
active.
The card may have been
installed while an application
was running, so the notebook
is not aware of it.
You may have the wrong I/O
address selected for your
card device.
The installed primary battery
is completely discharged,
there is no optional second
battery installed or there is no
power adapter installed.
Possible Solutions
See your software documentation and activate the correct driver.
Check parallel port setting in the BIOS and set to bi-directional or ECP.
Close the application and restart your notebook.
Remove and re-install the card. See "ExpressCards™" on page 72.
See your software documentation and activate the correct driver.
Close the application and restart your notebook.
See your ExpressCard documentation to determine
the required I/O address. Change the settings in the Device
Manager.
Check the Status Indicator Panel to determine the presence and condition of the
batteries. See "Status Indicator Panel" on page 22. Install a charged battery or a
Power adapter.
92 - Troubleshooting