Aiwa ADC-M65 YZ Operating Instructions Manual page 17

1
Press FNC repeatedly to select the desired band
(F1, F2, F3, MW or LW).
2
Press TUNEi (to move to higher frequencies) or
TUNEk (to move to lower frequencies) to tune in to
a station.
"ST" appears in the display when an FM station is
broadcasting in stereo, and receiving conditions are
good.
Seek Tuning and Manual Tuning
• Press and hold TUNEi or TUNEk until Seek
Tuning starts.
The unit locates a station automatically (Seek
Tuning).
• Press TUNEi or TUNEk repeatedly to search for
a desired station while increasing or decreasing
the frequency step by step (Manual Tuning).
To stop Seek Tuning, press TUNEi or TUNEk
again.
Monaural mode
When FM signals become weak, or FM reception
becomes poor, the unit automatically switches to
Monaural mode to reduce noise.
Using preset stations
You must preset stations before you can tune in a station
using preset station number buttons.
Presetting stations automatically
(Auto Memory)
1
Press FNC repeatedly to select the desired band
(F1, F2, F3, MW or LW).
2
Press and hold PS/A.ME until automatic presetting
starts.
The unit automatically stores up to 6 stations for
each band.
After completion of automatic presetting, the unit
tunes in to all the stations stored on the preset
station buttons in order (Preset Scan).
To cancel automatic presetting, press PS/A.ME again.
Preset station buttons 1 – 6
Preset station
number
Checking the preset stations (Preset Scan)
1
Press PS/A.ME briefly.
Each preset station will be tuned in for 5 seconds in
order.
To cancel Preset Scan, press PS/A.ME again or any
preset station button.
Presetting stations manually
(Manual Memory)
1
Press FNC repeatedly to select the desired band
(F1, F2, F3, MW or LW).
2
Press TUNEi or TUNEk to tune in to a desired
station (see "Tuning in to a station," page 3).
3
Press and hold the desired preset station button until
the unit beeps.
Note
A newly preset station replaces the station on the same
band that was previously stored on that preset station
button.
Tuning in to a preset station
1
Press FNC repeatedly to select the desired band
(F1, F2, F3, MW or LW).
2
Press the preset station button on which the desired
station is stored.
Active tuning reception control (ATRC)
The unit automatically suppresses FM noise caused by
vehicle movement, and maintains sound quality.
Radio data system (RDS) features
The following RDS features are available with this unit.
Important
• The RDS features are available only during FM
reception.
• You may not be able to activate the RDS features fully
in the areas where the station is test-broadcasting the
RDS signals.
Smart Jog
4 4
ENGLISH ENGLISH