3 3 3 3 . . . . 2 2 2 2 R R R R e e e e a a a a s s s s s s s s e e e e m m m m b b b b l l l l y y y y P P P P r r r r o o o o c c c c e e e e d d d d u u u u r r r r e e e e
Reassemble the disassembled parts in the reverse order of the disassembly procedure described
in 3.1.
C C C C A A A A U U U U T T T T I I I I O O O O N N N N : : : :
1. Route the cables very carefully so that they will not be caught.
·The flat cable should be located on the board side.
·Take care that the NPE sensor will not be cabled above the DIP switch.
2. Tighten the screws firmly, but avoid tightening them too hard.
3. Use only the attached screws.
unscrewed, be sure to put them back in their original places.
4. After reassembly, be sure to check prior to turning on the power.