Preparation - Fujitsu ABT30AG Operating Manual

Air conditioner ceiling suspension type
Hide thumbs

Advertisement

Table of Contents

PREPARATION

Load Batteries (R03/LR03 × × × × × 4)
1
Press and slide the battery compartment lid to open it.
2
Insert batteries.
Be sure to align the battery polarities (
3
Close the battery compartment lid.
Set the Current time
1
Press the TIME ADJUST button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the (
the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3
Press the TIME ADJUST button again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
G The remote control unit must be pointed at signal receiver to operate correctly.
G Operating range: About 7 meters.
G When a signal is properly received by the air conditioner, a beeping sound will
be heard.
G If no beep is heard, press the remote control unit button again.
Remote Control Unit Holder
For use as Handy Type
Screws
1 Mount the Holder.
For use as Wall Fixing Type
Screws
1 Mount the Holder.
6
)SET TIME buttons to adjust the clock to
Insert
2 Set the Remote
Control Unit.
Insert
2 Set the Remote
Control Unit.
) correctly.
Slide up
3 To remove the Remote
Control Unit (when use at
hand).
Slide
Screw
3 Attach the unit to the
holder as shown.
CAUTION!
G Take care to prevent infants from
accidentally swallowing batteries.
G When not using the remote control unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
G If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
G Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
G Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the remote control
unit's operating range becomes appre-
ciably reduced, replace the batteries and
press the ACL button with the tip of a
ballpoint pen or other small object.
SET
SWING
SET
SWING
TIME
TEST
ENERGY
ADJUST
RUN ACL
SAVE

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Fujitsu ABT30AG

Table of Contents