Setting The Time And Using The Timer; Setting The Current Time - Samsung Smart TV E-Manual

Setting the Time and Using the Timer

Setting the Current Time

System > Time > Clock
Set the clock manually or automatically. Once the clock has been set, you can select the
to check the current time.
"
The clock must be reset every time the power is disconnected.
Setting the Clock using Digital Broadcast Info
System > Time > Clock
Set Clock Mode to Auto. The TV automatically downloads the correct time from a digital channel. To
enable this option, the TV's Antenna jack must be connected to either an antenna or a cable output
and must be receiving digital broadcasts. The accuracy of the time information received may vary
depending on the channel and signal. If your TV is connected to a set-top-box or satellite box using
HDMI or Component connections, you must set the time manually.
"
Availability depends on the specific model and area.
If the Clock is Wrong in Auto Mode...
System > Time > Clock
If the time set automatically is incorrect, you can offset the clock in 1-hour increments by as much as
-/+ 12 hours. Select
"
Time Offset adjusts the time through network connections and is only available if the
Auto and the TV is connected to the Internet though a local area network.
"
Time Offset will adjust the time if the TV fails to receive time information through normal digital broadcast
signals.
Setting the Clock Manually
Manually enter the time. Set
time and date.
Clock Set: Set the current
Time Zone: Select your time zone.
"
This function is only available when the
DST: Switches the DST (Daylight Saving Time) function on or off.
"
This function is only available when the
GMT: Selects your time zone.
"
When Country is set to others, you can use this function.
Try Now
> Clock Mode
Try Now
> Time Offset
Try Now
System > Time > Clock
Clock Mode
Date and Time.
> Time Offset and offset the clock to the correct time.
to Manual and then select
Clock Mode is set to Auto.
Clock Mode is set to Auto.
Clock Mode
Clock Set to enter the current
INFO button
is set to