Hitachi RAC-10JH5 Instruction Manual page 12

AIR IN PRE-FILTER, EXHAUST PRE-FILTER, NANO-TITANIUM DISINFECTING
7
Removing the Fresh Air In Pre-Filter
Please pull out.
9
Attaching the Nano-Titanium Disinfecting
Deodorizing/Dust Collecting Fresh Air In
Filter
Nano-Titanium Disinfecting Deodorizing/Dust
Collecting Fresh Air In Filter (included)
11
Attaching the Fresh Air In Pre-Filter
Please hold the handle and install the filter by
pushing it along the inner grooves.
CAUTION
If the front panel is loose, the panel may come off and fall.
When opening the front panel, please do not use excessive force. If the front panel
comes off the device, this may cause it to malfunction.
Please do not operate the device without the pre-filter. If dust enters the machine, this
may cause it to malfunction.
When removing and installing the pre-filter, please take sufficient care not to cut your
hand with the fin of the heat exchanger.
8
10
12
Groove
– 1 2 –
Removing the Nano-Titanium Disinfecting
Deodorizing/Dust Collecting Fresh Air In
Filter Case
Please hold the
handle of the Nano-
Titanium Dis-
infecting Deodori-
zing/Dust Collecting
Fresh Air In Filter
Case and pull out.
Attaching the Nano-Titanium Disinfecting
Deodorizing/Dust Collecting Fresh Air In
Filter Case
Please hold the
handle of the case
and attach along
the slot, and then
keep pressing until
the case clicks.
I m p r o p e r f i l t e r
installation m a y
result in abnormal
noises.
Closing the Front Panel
Hold the front panel with both hands and pull
forward, then down.
Front Panel
Keep pressing the front panel in the direction of
the arrow (3 places) until the panel clicks.