Enamelled Parts; Replacing The Oven Light Bulb; Gas Taps - DeLonghi DTC 95 DF Operating Instructions Manual

ENAMELLED PARTS

All the enamelled parts must be cleaned with a sponge and soapy water or other
non-abrasive products.
Dry preferably with a microfibre or soft cloth.
Acidic substances like lemon juice, tomato sauce, vinegar etc. can damage the enamel
if left in contact for too long.
STAINLESS STEEL, ALUMINIUM PARTS, PAINTED AND SILK-
SCREEN PRINTED SURFACES
Clean using an appropriate product. Always dry thoroughly.
IMPORTANT: these parts must be cleaned very carefully to avoid scratching and abra-
sion. You are advised to use a soft cloth and neutral soap.
CAUTION: Do not use abrasive substances or non-neutral detergents as these
will irreparably damage the surface.

GAS TAPS

In the event of operating faults in the gas taps, call the After Sales Service Department.
FLEXIBLE TUBE
From time to time, check the flexible tube connecting the gas supply to the cooker.
It must be always in perfect condition; in case of damage arrange for it to be replaced
by a C.O.R.G.I. registered installer.

REPLACING THE OVEN LIGHT BULB

Switch the cooker off at the mains. When the oven is cool, unscrew and replace
the bulb with another one resistant to high temperatures (300°C), voltage 230 V
(50 Hz), E14 and same power (check watt power as stamped in the bulb itself) of the
replaced bulb.
Note: Oven bulb replacement is not covered by your guarantee.
25