How to Fix Installation Plate
The wall you select should be strong and solid enough to prevent
vibration
1. Mount the installation plate on the wall with four
type A screws. If mounting the unit on a concrete
wall, use anchor bolts.
Mount the installation plate horizontally by
aligning the centerline using a level.
Installation Plate
Type "A" screw
2. Measure the wall and mark the centerline. It is also
important to use caution concerning the location
of the installation plate-routing of the wiring to
power outlets is through the walls typically.
Drilling the hole through the wall for piping con-
nections must be done safely.
Left rear piping
50mm
30k
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
Right rear piping
ø 70mm
180mm
- 15 -
Drill a Hole in the Wall
I Drill the piping hole with a ø70mm hole core drill.
Drill the piping hole at either the right or the left
with the hole slightly slanted to the outdoor side.
WALL
Indoor
Installation
Outdoor
LGE Internal Use Only