Two-Piece Front Turn Signal Lamps - Chevrolet 2003 S10 Pickup Owner's Manual

Two-Piece Front Turn Signal Lamps
1. Remove the headlamp assembly as shown in
"
Two-Piece Composite Headlamp SysteM
under Headlamps on page 5-55
2. Locate the locking tabs
on the assembly.
Squeeze the tabs
together and push that
end of the assembly
out while holding
the tabs. The assembly
will swing out.
3. Unplug the electrical connector.
4. Turn the harness bulb socket counterclockwise to
remove it. Pull the bulb straight out to remove it
from the socket.
5. Push the new bulb into the socket until it snaps into
6. Put the socket into the lamp assembly and turn it
7. To reinstall the assembly, snap the outboard end of
place.
clockwise until it is tight.
the lamp assembly back into the vehicle. Then
swing the assembly in and snap it into place.
8. Install the two retaining clips.
9. Close the hood.
5-58