Setting Up The Player; Using The Setup Screen Menus - Pioneer DV-525 Operating Instructions Manual

Setting Up the
Player

Using the Setup Screen Menus

The procedure on this page describes how to operate the
menus on the Setup screen. These menus are used to
set and adjust a number of system settings. The various
functions that can be adjusted are covered throughout
this manual. The procedure on this page provides a basic
outline for using the Setup screen menus.
When setting up for the first time
Some DVDs start playing automatically when loaded in
the player. It is therefore recommended to set the
Audio 1 menu options (if digital audio connections have
been made) and Video menu options before loading a
DVD for the first time. If a DVD has been loaded, be sure
to press 7 (stop) before proceeding.
Procedures in this section use the DV-525K and the
DV-525 (Taiwan model) as models. Differences in procedures
between models are clearly marked by white numbered steps.
Note
The default on-screen display language of the DV-525K is
Chinese. If you would like to switch the display language to
English to use the menu screens, make changes to the [OSD
Language] setting in the Setup screen Language menu (page 23).
1
5
4,5
4
1
3
e 8
S T A N D B Y / O N
1(1)
1
Press STANDBY/ON
on the remote control). (DV-525K and DV-525
(Taiwan model) only)
1
Press POWER on the front panel. (DV-525
only (except for Taiwan model))
2
¢
3,6
¡ 7
E
0
4 1 ¡ ¢
7 8
3
on the front panel (
2
Press SETUP.
The Setup screen appears.
(Example)
2 Video Language
Audio1
Dolby Digital Out – Dolby Digital
DTS Out – Off
96kHz PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Move
3
Use the cursor buttons (2/3) to select the
menu you want.
As each menu is selected with the cursor, the
settings appear below the menu heading.
4
Press the cursor button (∞) to enter the
menu.
The top item within the menu becomes highlighted.
(Example)
2 Video Language
Audio1
Dolby Digital Out
DTS Out -
96kHz PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Move
5
Use the cursor buttons (5/∞) to select the
setting you want to change.
The options available for each setting appear to the
right when the setting is selected. The current
setting appears with the setting indicator lit.
6
Press the cursor button (3) to enter the
setting options.
(Example)
2 Video Language
Audio1
Dolby Digital Out
DTS Out -
96kHz PCM Out – 96kHz 3 48kHz
MPEG Out – MPEG 3 PCM
Move
ENTER
• Not all menu options can be changed while a disc
is playing. In these cases, the options appear
grayed out on the screen and cannot be adjusted.
To change these settings, press 7 (stop) first
before pressing SETUP.
• Operating the menu after pressing 7 (stop) may
cancel the resume function.
• Some menu options are not immediately
effective if set while a disc is playing. To make
these settings effective, stop playback and then
start again, or change the settings while the disc
is stopped.
General
Exit
SETUP
General
Dolby Digital
Dolby Digital 3 PCM
Exit
SETUP
General
Dolby Digital
Dolby Digital 3 PCM
Select Exit
SETUP
continued
19
En