Assembly Instructions - Yard-Man Snow Fox Operator's Manual

Electric

Hide thumbs

Table of Contents

Available languages

ASSEMBLING THE HANDLEBARS

Before you can operate the unit, you must

handlebars.

1. When you unpack the unit, loosen

two knobs and washers from the inside of the lower

bars (Fig. 1).

2. Hold the handle bar in the position shown in Figure 1

and slide it onto the lower bars making sure that the

ends of the handlebar are on the inside of the lower

bars.

3. Align the holes in the handlebar with the holes in the

lower bars and insert the bolts through those holes.

NOTE: Take care not to pinch the switch

positioning the handlebars.

4. Place the washers on the bolts, then screw the two

knobs onto them.

5. Tighten the knobs to secure the handlebars in place.

NOTE: Do not over-tighten the knobs.

6. Clip the switch cable to the cable restraint on the

lower bar as shown in the inset of Figure 1.

USING THE CORD RETAINER

There is an extension cord retainer to prevent the

extension cord from disconnecting during use. The

retainer hangs from the cord guide bar.

NOTE: Do not plug the extension cord into the power

source receptacle until the cord is connected to

the cord retainer and plugged into the unit.

To use the cord retainer:

1. Fold the extension cord in half, forming a tight loop

near the receptacle.

2. Push the loop through the bottom hole in the retainer

(Fig. 2).

3. Slide the loop over the retaining clip and pull down

until the cord fits snugly (Fig. 2).

NOTE: Use a UL-approved extension cord. A 100-foot,

14-gauge cord is recommended. A 50-foot, 16-

gauge cord is acceptable.

Both the cord retainer and guide bar restrain the

extension cord and keep it out of the way at all times,

safely to the side of the operator.

The extension cord and retainer will slide on the guide

bar as the unit is moved to the left and right. Connect

your extension cord to the unit as shown in Figure 3.