How To Assemble Panel And Base Unit - Olorin VistaLine VL157D User Manual

How to assemble Panel and Base unit

The product normally comes in 2 cartons and you need to assemble the panel and the base unit.
A screwdriver and proper screws are included in the box for the base unit.
1. Remove the back of the base unit by grabbing it firmly at the top and pulling it up and
backwards.
2. Place the monitor with the front down on a level surface. Make sure that there are no objects
on the surface that could damage the panel element. It should be placed so that the OSD
wheel is at the lower left corner seen from yourself.
Place the metal plate onto the VESA mounting cut-out on the back of the panel. Hold the
bottom of the base unit towards yourself.
Test that you can swing the base unit to the left so that swivel between Landscape and
Portrait will be correct.
3. Locate the holes in the back of the base unit through which you can stick the screwdriver to
reach and put the 4 screws in place.
4. Remount the back cover.
If you mount any device using these 4 holes on the back of the panel you must not
use use screws longer than 10 mm. Longer screws will cause damage which is not
covered by the product warranty.
Caution
15