Sony MZ-R701 Service Manual page 2

MZ-R701/R701DPC
Battery life
1)
Batteries
NC-WMAA Nickel Cadmium
rechargeable battery
3)
LR6 (SG)
Sony alkaline dry battery
4)
The battery life may be shorter due to operating conditions, the
1)
temperature of the location, and varieties of batteries.
2) Measured value by the standard of JEITA (Japan Electronics and
Information Technology Industries Association).
3) When using a 100% fully charged rechargeable battery.
4) When using a Sony LR6 (SG) "STAMINA" alkaline dry battery
(produced in Japan).
Dimensions
Approx. 81 × 28.1 × 74.4 mm (w/h/d)
without projections.
Mass
Approx. 118 g the recorder only
Supplied accessories
NC-WMAA nickel cadmium rechargeable battery (1)
AC power adaptor (1)
Headphones/earphones with a remote control (1)
Optical cable (1)
Rechargeable battery carrying case (1)
Carrying pouch/carrying case with a belt clip (1)
Design and specifications are subject to change
without notice.
2
(Unit: approx.hours) (JEITA
Stereo LP2 LP4
Recording 4 6 7.5
Playback 13 14.5 18
Recording 9 13 16
Playback 40 46 53
Flexible Circuit Board Repairing
)
2)
• Keep the temperature of the soldering iron around 270°C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous
radiation exposure.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL
OR IN SUPPLEMENTS PUBLISHED BY SONY.